Why Is My Side Airbag Off Light On?

Why Is My Side Airbag Off Light On?

Why Is My Side Airbag Off Light On? If your car has this light, it is because the car has a feature to disable the passenger airbag, so that a rear-facing baby carrier can be used in that seat.
This function is usually activated by a switch, maybe that you have to turn with the key, often in or around the glovebox.

What does it mean when it says side airbag off? Your passenger airbag will turn off if your passenger is: Light enough that the weight sensor detects that someone is occupying the seat, but not heavy enough that deploying the airbag is a wise idea. The sensor believes the person sitting in this chair is too light and deploying the airbag would be unsafe for them.

Why does my side airbag light come on and off? When this light is on, that means your airbags are deactivated. It means they will not deploy properly if you get into an accident. If your car’s battery has drained recently, it may have also depleted the backup battery that powers the airbags.

How do I reset my airbag light? How to Reset an Airbag Light
Put the key into the ignition and turn the switch to the “on” position.
Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
Repeat Steps 1 and 2 two more times.

Why Is My Side Airbag Off Light On? – Related Questions

How do I turn on passenger side airbag?

The switch for the passenger airbag is located on the passenger end of the instrument panel and is accessible when the passenger door is open.
Check that the switch is in the required position.
ON – The airbag is activated and all front-facing passengers (children and adults) can sit safely on the passenger seat.

Is it safe to drive with airbag light on?

It is not safe to drive with the airbag light ON. When the light is on, it means that there is a problem with the airbag system. When there is a problem with the system, it will not deploy the airbags at all in an accident. If your airbags are not functional in a crash, it may cause death or serious injuries.

What does the airbag light look like?

The SRS warning light on the dashboard usually looks like a side view of a person sitting in a seat with a seat belt on, with a large circle (the airbag) in front of the person. It will normally light up briefly each time you start your vehicle, and then go off.

How do I know if my airbag sensor is bad?

The way you know if the sensor is at fault or not, before scanning your airbag system for faults, is to simply look at the “Passenger Airbag Off” light. If there’s no one in the seat, the light should illuminate. If there is someone in the seat, the light should turn off, signifying that the system is armed.

Where are the airbag sensors located?

The location of airbag sensors differs from car to car. The most common location is inside the front bumper or fender, however many modern vehicles have several airbag sensors. They can also be found inside the engine bay, in the passenger seat area, or even in the rear or sides of the vehicle.

How much does it cost to fix airbag light?

How do I turn off the airbag light?

How to Turn Off the Airbag Light
Turn on the ignition switch with your car key.
Wait for the airbag warning light to turn off.
Turn the ignition switch of your car back off for a little longer than three seconds.
Repeat steps 1 through 3 twice to make three times total.

Can you reset airbag light without tool?

How to reset airbag light without a Scanner. In some older cars, though, it is possible to reset the airbag light without a scanner by removing the car battery terminals. Check the wiring system underneath the driver or passenger seat for any loose wires or corrosion in the connector plug.

Is passenger airbag supposed to be off?

So, is the air bag always on or always off

Where is the airbag cutoff switch?

The PACOS is usually located in the passenger side of the dash board. It may be on the dashboard itself, in the glovebox or on the side of the dash so that you need to open the passenger door to access the switch.

How do you activate the airbag?

Make sure the passenger is sitting upright in the seat. Turn on the vehicle, wait for the air bag control to signal ON, and then keep the person and the seat in the same position for one minute. After one minute, the passenger can adjust their seat and sitting position, and the air bag will stay on.

What happens if your airbag light is on?

When this light comes on, it indicates that a problem has been detected in the system, and one or more airbags may not inflate in the event of a collision. While it’s possible that all the airbags could work as intended even with an SRS warning light, a failure in the airbags is a significant safety concern.

Can you sell a car with airbag light on?

In California, No, you cannot legally sell a vehicle with a faulty SRS/Airbag system.

What do you do when your SRS light comes on?

When you turn the ignition key to the “ON” position, the SRS light should come on momentarily, then extinguish. If the SRS light stays on, there’s a problem with the system and the air bags may not deploy in the event of a crash. You’ll want to seek professional diagnosis and repair as soon as possible.

Can a blown fuse cause the airbag light to come on?

Blown fuses can definitely cause the airbag light to come on. When the airbag system is malfunctioning, a mechanic or auto parts store should be able to read the code that the system is putting out which will give them a clue as to what particular problem the airbag is having.

How much does it cost to fix a seat belt sensor?

A clock spring or crash sensor may run around $75 to $125, a seat belt with pretensioner may cost you around $200 to $300, and the computer itself could run upwards of $800 to $1000. Keep in mind, pricing will vary by location and your vehicle make and model.

How do you check airbag codes?

Airbag Diagnostic Codes

Frank Slide - Outdoor Blog
Logo
Enable registration in settings - general