How Much Transmission Fluid Does A Ford Aod Hold? Earlier Fords used type FA fluid, but the AOD requires 12 quarts of Mercon V fluid to fill the transmission and torque converter.
How much fluid does an automatic transmission hold? In general, transmissions take about 9 to 13 quarts to fill completely. The amount of transmission you add will vary, depending on whether you are draining or replacing it all or you are just topping it up. Again, you should avoid adding too much. It is advisable to put in little amounts at a time.
How strong is a Ford AOD transmission? The bulletproof nature of the Ford AOD transmission can be unraveled just by knowing the right buttons to push. When that has been put in place, you can boost its performance from about 400 hp to as high as 1,200 hp which makes for excellent speed while racing.
How much HP can a Ford AOD handle? Because of this odd power flow, Lentech’s Len Bertrand tells us a stock AOD can handle 450 hp, at best, and will always be hard on 3/OD clutch packs.
How Much Transmission Fluid Does A Ford Aod Hold? – Related Questions
How do you check the transmission fluid on a Ford AOD?
Automatic transmissions must be at operating temperature, this means they have to be driven some, then park it on a level surface still running, foot on the brake pedal and run the gear selector through all the gears and wait for each one to engage before going to the next, then when you get to Park, pop the hood,
What happens if you put too much transmission fluid in?
Transmission Fluid Leakage: Adding too much fluid will cause high pressure inside of your transmission. This is very bad and could cause your transmission to start leaking fluid everywhere. This can cause wear and tear on your transmission and damage the system in the long run.
How much transmission fluid does a 48RE hold?
Chrysler 48RE Specs
Transmission: Chrysler 48RE
Max Input Torque: 560 – 570 lb-ft (Chrysler strength designation “8”)
Weight: ~248 lbs
ATF Type/Spec: ATF+4 automatic transmission fluid
Fluid Capacity: 14.5 – 16.5 dry fill capacity, approx 4 qts service refill capacity
7 more rows
How much horsepower can a AOD transmission handle?
This unusual system can accommodate up to 450 hp or so before pieces start snapping. A sturdier single-shaft arrangement keeps the converter from locking up in Third and Fourth gears, and this alone makes a worked AOD effective into the 600hp range.
What year AOD is best?
’89-’93 are the best years for the AOD, they already have the better internals for anything with horsepower.
How can you tell if a transmission is AOD?
The AOD transmission can be identified in several ways. Its prominent 14-bolt pan is probably the easiest way. The pan is basically square but the back two corners are tucked in a little tighter than the front corners making the pan look like home plate with the front point cut off.
How much can a stock AOD handle?
Looking through all the trans build-ups on the Network 54 forums, and TCCOA, etc, the max torque a properly built AOD can handle is about 450 lb/ft.
Is a Ford AOD transmission electronic?
The AOD (automatic overdrive) is a four-speed automatic transmission, with the 4th gear as overdrive. Introduced in 1980, it was Ford’s first four-speed automatic overdrive transmission. The gearset design is based on the Ford “X” automatic transmissions used during the 1950s, ’60s, and ’70s.
Ford AOD transmission.
AOD
Overview
Successor 6R
7 more rows
Are all AOD transmissions the same?
All our AOD transmissions share the same gear ratios: 2.40:1 on the first gear, 1.47:1 on the second, 1:1 on third and 0.67:1 on fourth.
How do you check the transmission fluid on a 2003 Ford Mustang?
Transmission Fluid Level Check Ford Mustang (1994-2004)
Getting Started – Prepare for the repair.
Open the Hood – How to pop the hood and prop it open.
Remove Dipstick – Access point for transmission fluid.
Check Level – Insert dipstick and pull it out to determine level.
Can I use Mercon V instead of mercon?
Automatic transmissions, power steering systems and manual transmissions previously requiring MERCON must, as of July 1, be serviced with MERCON V. “All transmissions which recommended using MERCON ATF can now be serviced with MERCON V,” said Ron Romano, FCSD Service Lubricants Technical Expert.
How do you check the transmission fluid on a 2003 Mustang GT?
Pull the transmission dipstick from its tube. On a Mustang, the transmission dipstick is located on the passenger side of the engine, between the engine and the transmission. The top of the dipstick will be curled into a circle.
Can I add new transmission fluid to old?
You can just add new fluid without draining some, unless you are replacing what has leaked out. The transmission doesn’t have a plug like the oil pan either, you have to loosen the bolts all the way around the pan and be prepared to replace the gasket when you get ready to close.
Can the transmission be damaged by changing the transmission fluid?
Transmission fluid is important for lubricating the parts of your transmission and reducing wear and tear caused by friction and heat. While changing your transmission fluid won’t damage the condition of your transmission, if you haven’t been changing it frequently enough, you may discover that your transmission slips.
Can I just add transmission fluid?
Usually, you should not have to add transmission fluid. If the level is down significantly below the “Add” or “Cold” line, you probably have a system leak and should take the car to your mechanic to have your car inspected for leaks by a technician.
How much transmission fluid does a 47RE hold?
Fill the transmission with new ATF through the dipstick tube. The service refill capacity on the 47RE and 47RH transmissions is approximately 4 quarts, but this is only an estimate. Reinsert and check the fluid level frequently as you add fluid to prevent overfilling.
Is the 48RE a good transmission?
The main weak spots, in general, of the 48RE are: line pressure, torque converter and the input shaft due to it’s locked 3-4 shift. Other than those, they’re a pretty good towing transmission.
